Software Installation
If you have an external weather station, connect it to the data acquisition interface.
Then connect the data acquisition to the PC through the USB cable.
Download the latest version of the installer from the download page.
Run the installer and follow the instructions on the screen.
Installation Wizard
The installation wizard runs the first time you open the software.
-
The frist stage is the identification of the hardware model. If a
HARDWARE NOT DETECTED
message appears, check all connections and try again. -
The next step is the selection of the brand and model of the dyno. We currently have a database of the different models of the
MWD
brand. If your bench is not an MWD brand, select 'Other Manufacturer' option. -
Once the brand has been identified, select the type of dyno and then select the
moment of inertia
and thediameter
in case of a chassis dyno. The moment of inertia is provided by the dyno manufacturer. If you don't have the moment of inertia, you can enter any value. You can change it later from theOptions
Settings
Inertia
menu. -
Next, the weather station unit will be detected. In the case of older hardware models, it must be selected manually.
-
At the end of the
Installation Wizard
you will be given the option to activate the software.
Factory Reset
If you wish to run the installation wizard again, you can do so from the Help
menuInstallation Wizard
. This is useful in case you need to reconfigure the system or reset it to its original factory settings.